+1 877-337-9312 | info@arcacoustics.com

‹ Back to previous page

VIBRO-SHR

VIBRO-SHR offers a combination of special rubber with metal spring for better vibration isolation of low and high frequency heard by the human ear.

Categories: ,

Description

Anti-Vibration Hanger with Rubber and Spring

VIBRO-SHR is a combination of special rubber with a metal spring for better vibration isolation of low and high frequency heard by the human ear.

VIBRO-SHR can be used for antivibration hanging for sound insulating false ceilings, antivibration suspension of pipes, air-ducts, loudspeakers etc.

This hanger consists of:

  • Steel frame with a painted finish or galvanised protection
  • Steel spring in according to DIN standard with a galvanized finish.
  • Steel cup to prevent spring movement.
  • Rubber element (polyurethane foam with semi closed cells)
  • Rod with safety nut (upon request)
  • Preloading capability by turning the bottom nut
  • Rubber spring cup with a projecting bushing to prevent sound bridge

Dynamic Characteristics

Deflection: 25 mm at maximum load

Natural Frequency: 3 Hz at maximum load

Other load range upon request

Related products

  •
    Quick View
    Ceiling Noise Control VIBRO-CH Mini

    VIBRO-CH Mini consist of a metal frame made of galvanized steel with notches in appropriate places and the antivibration mount Vibro mini.

  •
    Quick View
    Ceiling Noise Control RSIC-DC04X2

    This line of clips are very versitile and available in a variety of acoustic design loads from 36lbs to 144lbs. Minimum cavity of ½” to 4-½” depending on load capacity requirements. Applications include: dropped ceilings, isolation of garage door motors, garage door rails, speakers, vent fans, recessed lighting, projector mounts, electrical boxes, ceiling fans and even for the decoupling of walls built within other walls.

  •
    Quick View
    Ceiling Noise Control RSIC-1 ADM Side Mount

    Designed to be used with an open web steel truss application where noise reduction is required. Installation involves hammering on the clip and spin the isolator to adjust up and down for a level ceiling. Secure the side mount with two strands of 18 Ga wire. Minimum cavity of 1-¾”, maximum of up to 12″.

  •
    Quick View
    Ceiling Noise Control RSIC-1 ADM Mini Drop in Anchor

    Designed to be used with concrete ceilings where noise control is required. Easy installation involves by drilling a hole in the concrete, inserting the mini drop in anchor, setting with the setting tool and threading in the RSIC-1 ADM. Height can be adjusted by spinning the isolator for a level ceiling.